25
16
10
REAR
25
16
10
25
16
10
TM
ERG4 COMFORT CRIMP
®
COMPRESSION TOOL WITH SHURE STAKE
®
MECHANISM
For Installing Ferrules 26-1/0 AWG (0.14-50 mm
2
)
IMPORTANT:
Read and understand all of the instructions and safety
information in this manual before operating or servicing this tool.
In the event the SHURE STAKE
®
mechanism must be released, please see Figure 5.
TA04536 D Page 1 of 2
1. Remove die screws from frame with supplied torx wrench.
2. Choose an appropriate die set to match wire gauge.
3. Insert die set into frame. Ensure the rear side of die set
faces the main axle of the frame.
4. Install die set screws loosely and close the handles while
ensuring proper alignment of the die halves.
5. Tighten the die screws with supplied torx wrench.
Die Set Installation
1.2
Figure 3
Figure 2
1.1
1.0
INSTRUCTIONS FOR USE
1. Open handles fully.
2. Position ferrule into the
proper nest.
3. Close handles slightly to secure
ferrule. Do not deform ferrule.
4. Insert stripped wire
5.
Close handles until the SHURE STAKE
®
mechanism cycle has been completed.
For Use With
Ferrules 26-1/0 AWG (0.14-50 mm
2
)
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
Figure 1
Insert
Die Screws
Main Axle
