JST AP-K2, Руководство по эксплуатации

Страница: 14 / 36

H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2\TS009-02 AP-K2 Operation Manual.doc
14
5.2 Bell Mouth Adjustment
When using the MK-L Applicator
Adjust the terminal feed position with reference to the bell-
mouth position. Refer to section 6.1
When using the MKS-L Applicator (old type)
Move the entire feed-plate to obtain the desired bell-mouth
crimp. First, loosen the feed-finger retaining screw in the
feed-finger holder. Next, loosen the two cap head socket
screws in the slots on the base of the applicator (see
photograph).
With the aid of a flat ended screwdriver, rotate the adjusting
screw in the front of the adjustment carriage, turn the screw
clockwise to increase the bell-mouth (move the guide rails
towards the front of the press), and counter-clockwise to
decrease the bell-mouth (move the guide rails towards the
back of the press).
Re-tighten the adjustment screws on the base of the
applicator, centralise the feed-finger in the slot in the guide
rail and tighten the screw.
Check the bell-mouth on the resultant crimp and re-adjust if
necessary.
When using the MKS-L Applicator (new type)
Move the entire feed-plate to obtain the desired bell-mouth
crimp. First, loosen the feed-finger retaining screw in the
feed-finger holder. Next, loosen the two hexagon-headed
bolts situated on the front of the adjustment carriage just
above the top surface of the applicator base-plate.
With the aid of a 5mm hexagon key, rotate the screw in the
front of the adjustment carriage, turn the screw clock-wise to
decrease the bell-mouth (move the guide rails towards the
back of the press), and counter-clockwise to increase the
bell-mouth (move the guide rails towards the front of the
press).
Re-tighten the adjustment bolts, centralise the feed-finger in
the slot in the guide rail and tighten the screw.
Check the resultant crimp and re-adjust if necessary.
There is a crimping manual available from the JST Technical
Department detailing the points to inspect on a crimped
terminal to achieve results as per our specifications.
A copy is issued with every AP-K2N Crimping machine
supplied to a customer but please contact JST if you require
further copies.
Slot-head adjustment screws
Feed-finger screw Adjustment screw
Hexagon nuts
Adjustment screw