JST AP-K2, Руководство по эксплуатации

Страница: 6 / 36

H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2\TS009-02 AP-K2 Operation Manual.doc
6
3. MACHINE PREPARATION
3.1 Mounting the Reel hanger
Due to packing considerations, when you receive the machine the Reel hanger is not mounted on the
machine. Assemble the Reel hanger then mount it on the machine as illustrated below.
Step 1
Assemble the Reel hanger as shown in the photo
below.
Step 2
Mount the Reel hanger on the Crimping machine.
3.2 Mounting the Applicator
Step 1
Loosen bolts A and B with a 5mm hexagon
wrench supplied with the tool-kit.
Step 2
Remove the protective rubber collar from under the
dials on the applicator ram.
Step 3
CAUTION
Ensure that the shank is correctly located in the
ram. There is a danger of major tooling damage if
the tooling is not located correctly (as in the
photograph below).
Step 4
Securely fasten the clamps with the 5mm hexagon
key, and visually check that the tooling is mounted
correctly.