JRC JMR-5410-4X, Инструкция по эксплуатации

Страница: 154 / 688

Section 3 Common Basic Operations 3-28
3.15 Cursor AUTO Mode
The cursor AUTO mode (referred to as AUTO mode henceforth) is a function that automatically
executes the function (operation) that is assigned to the object when the object under the cursor is
clicked on.
The AUTO mode is effective for the following objects.
Object
Section that describes the function (operation) to
be executed
No object (when the button is clicked on the
position without a valid object under the AUTO
mode on a chart/PPI)
3.15.1 No object
AIS 3.15.2 AIS
TT
3.15.3 TT
(AZ) Acquisition/Activation Zone 3.15.4 (AZ) Acquisition/Activation Zone
AIS filter 3.15.5 AIS filter
User map 3.15.6 User map
EBL
3.15.7 EBL
VRM 3.15.8 VRM
EBL/VRM intersecting point 3.15.9 EBL/VRM intersecting point
PI
3.15.10 PI, 4.6 Using Parallel Index Lines (Pl)
Monitoring dragging anchor
3.15.11 Monitoring dragging anchor
3.15.1 No object
When the button is clicked on the position without a valid object under the AUTO mode on a chart/PPI,
the following operation is performed.
Acquires the TT target manually when the button is clicked on inside of the PPI.
Memo
Manual acquisition is not allowed in any of the following cases:
• Radar antenna standby state
• Occurrence of target tracking function alert.
• Occurrence of ship's heading alert.
• Using at the position further than 32 NM from the own ship’s position
• Using at the position closer than 0.1 NM from the own ship’s position