JRC JMR-5410-4X, Инструкция по эксплуатации

Страница: 442 / 688

Section 14 Adjusting and Setting up Equipment (for Services) 14-16
14.3.2 Setting a serial port
Verify the setting of the serial port of this equipment and perform initial setting by using the [Serial Port]
dialogue.
[Operation procedure]
Open the [Serial Port] dialogue by performing the following menu operations.
[Menu] button
→ Service → Installation → System Configuration → Serial Port
14.3.2.1 [Diagnosis] lamp light colours
The [Diagnosis] lamp displays the diagnosis result as to whether the sentence of a sensor specified for
each serial port is received and the status of ISW/MTR/OPU.
Lit in red: Data not received.
Lit in green: Data is receiving.
Lit in orange:
In diagnosis (before decision).
No colour: Serial port is disabled.
14.3.2.2 Setting a serial port
In the [Serial Port] dialogue, allocate sensors to be connected to the serial port on RPU (central
processing unit) and the serial port on SLC.
[RPU] tab
[Setting a serial port on RPU]
Set each item as follows.
“Table A Sensors that can be selected by serial ports on RPU” shows selectable sensors.
However, the sensors that actually can be selected vary depending on the equipment setting.
For the sensor communication speed, refer to "Selectable baud rates".
Setting Item Description of Setting Setting Value
GPS 1. Select the [RPU] tab.
2. Enable the serial port for GPS by selecting the [GPS]
check box.
3. Select a sensor to be connected to the serial port for
the GPS from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
To enable: Select.
To disable: Clear.
Refer to Table A for
selectable sensors.
Gyro Compass 1. Select the [RPU] tab.
2. Enable the serial port for Gyro Compass by selecting
the [Gyro Compass] check box.
3. On the [Sensor] combo box, select a sensor to be
connected to the gyro compass serial port. When not
selecting a sensor, select 0.1.[-].
To enable: Select.
To disable: Clear.
Refer to Table A for
selectable sensors.