33
3. How removing the Burning Pot
Let open the combustion chamber door and remove both the pellet
chute slide (
F
ig
. 4
) and the burning pot by lifting upright. (
F
ig
. 5
).
A careful cleaning of the burning pot is required so that all holes
are duly swept.
Before replacing the burning pot, it is necessary to make sure that
there is no ash or dirt stacked in the burning pot casing.
Clean also carefully this component.
2. How getting empty the ash tray
Let open the combustion chamber door and pull out the tray located
under. (
F
ig
. 3
).
Once removed and emptied the tray, clear the residual ashes in its
support base by means of a vacuum cleaner.
4. H
ow placing the Burning Pot and Pellet Slide
After cleaning the burning pot make sure to replace it properly
(
F
ig
.
7
). The ignition resistance has to be properly centred in the burning
pot casing and the support seat must be standing level with the
casing compartment (
F
ig
. 6
).
Check that the gasket located under the burning pot is correctly
placed and embedded in the apposite slot. (
F
ig
. 8
)
Replace also the pellet loading slide (
F
ig
. 14
).
Insert both strips of the pellet slide into the apposite slots, the one
located on the burning pot support surface (
F
ig
. 9
) and the other
one next to the pellet outlet conduct (
F
ig
. 10
).
Once embedded, the pellet slide right side must be juxtaposed with
the right side of the combustion chamber (
F
ig
. 14
).
•
Stove Ordinary Maintenance and Conduction
1.
How refilling the Humidifier:
Let open the combustion chamber door and lift up the strip of the
humidifier iron window (
F
ig
. 1
).
Slot the small pomp pipe into and refill (
F
ig
. 2
).
F
ig
. 2
F
ig
. 1
F
ig
. 3
F
ig
. 4
F
ig
. 5
F
ig
. 6
F
ig
. 7
F
ig
. 8
F
ig
. 9
Содержание I-DEA Angolo
Страница 42: ...42 NOTES...
Страница 43: ...43...
