Johnson Controls York Smart Equipment SC-EQ, Руководство по установке

Страница: 37 / 52

JOHNSON CONTROLS
37
FORM 450.50-N1
ISSUE DATE: 08/19/2019
4
SECTION 4 - SC-AP GATEWAY
SC-AP OPTIVIEW MOUNTING
The SC-AP Installation Kit (p/n 331-03608-000)
contains all of the materials needed to install the SC-
AP into the OptiView chiller control panel using a DIN
rail in new panels or velcro for older panels.
OptiView DIN Rail Panel Mount
1. New production panels have 3" piece of DIN rail
installed to mount the SC-AP. The SC-AP instal-
lation kit contains two DIN rail end blocks to hold
the SC-AP in place on the DIN rail.
2. Install one end block (p/n 025-29189-000) to the
back end of the DIN rail, as shown in Figure 40
on page 37 .
3. Pull the SC-AP case bottom mounting bracket
clip outwards from the case.
4. Hang the SC-AP on the DIN rail and push the bot-
tom mounting bracket clip upwards to secure the
SC-AP to the DIN rail.
5. Install the second Din rail end block (p/n 025-
29189-000) to the front end of the DIN rail, as
shown in Figure 41 on page 37 .
O
ptiView Velcro Panel Mount
1. On older panels that do not have a DIN rail mount-
ed, the SC-AP should be mounted using the velcro
parts of the Installation Kit.
2. Install the four round velcro fasteners (p/n 025-
47586-000) to the four mounting holes on the
back of the mounting bracket using four screws
(p/n 021-34098-000), as shown in
Figure 42 on
page 37 .
3. Stick one of the four square velcro pieces (p/n
025-47587-000) on to each of the four round vel-
cro fasteners.
4. Remove the protective backing from the square
velcro pieces, and carefully stick the SC-AP in the
desired mounting location.
LD20431
LD20432
LD20433
FIGURE 40 -
DIN RAIL END BLOCK
FIGURE 41 - SC-AP MOUNTED
FIGURE 42 - SC-AP VELCRO PADS