2. CONNECTION TO TRACTOR
PIGB-206X-02 FCT1460 0614
- 32 -
SHORTENING OF THE PTO DRIVE SHAFT
It is necessary to be very careful when shortening the PTO drive shaft. If the PTO
drive shaft is shortened too much, there is a risk that the profile tubes are drawn
apart which may cause serious damage.
Especially on hilly ground when the machine and the tractor have variable angles in
relation to each other. On the other hand, if the PTO drive shaft is not shortened
enough there is a risk of squeezing during sharp turns, which may cause high
frictional forces in the PTO drive shaft, which again will damage the axle joints.
Fig. 2-12
Fasten the halves of the shaft to PTO and PIC (fig. 2.10), respectively, when these
are right opposite each other with the machine in working position. (The longest
distance on this machine). Hold the shaft ends parallel to each other and mark the
required shortening, minimum 200 mm overlapping. Shorten all 4 tubes equally.
The ends of the profile tubes must be rounded off and burrs must be removed
carefully. It is very important that the tubes are smooth and clean before greasing.
Grease the tubes carefully before reassembling.
WARNING:
Never turn so sharply that there are less than the prescribed 30
mm distance in order not to bottom the shaft. See measurement
a in fig. 2-10.
If the PTO drive shaft bottoms when turning sharply, there is a
risk that the shaft and/or other transmission parts are damaged.
FRICTION CLUTCH
On the PTO drive shaft between the drawbar and the gearbox there is a friction
clutch which ensures that the machine is not overloaded during operation.
Before starting a new machine, the clutch must be "aired". See section concerning
the friction clutch in chapter 7 "MAINTENANCE".
Fig. 2-12
Содержание FCT King Size 1260
