Jeep WRANGLER 2020, Руководство пользователя

Страница: 318 / 548

316 SAFETY
4. Remove slack in the tether strap according
to the child restraint manufacturer’s
instructions.
Suitability of Passenger Seats for i-Size
Child Restraint System Use
The rear outboard seats of the vehicle are
type-approved to house the state-of-the-art
i-Size child restraint systems.
These child restraint systems, built and
type-approved according to the i-Size (ECE
R129) standard, ensure better safety
conditions to carry children on board a vehicle:

The child must be transported rearward
facing until 15 months:

Child restraint system protection is increased
in the event of a side collision:

The use of the ISOFIX system is promoted to
avoid faulty installation of the child restraint
system:

Efficiency in the choice of the child restraint
system, which isn't made according to weight
anymore but according to the child's height,
is increased:

Compatibility between the vehicle seats and
the child restraint systems is better: the i-Size
child restraint systems can be considered as
"Super ISOFIX"; this means that they can be
perfectly fitted in type-approved i-Size seats,
but can also be fitted in ISOFIX (ECE R44)
type-approved seats.
NOTE:
The vehicle seats, i-Size type-approved, are
marked by the symbol shown in Figure XX.
Figure XX
WARNING!

An incorrectly anchored tether strap could
lead to increased head motion and
possible injury to the child. Use only the
anchorage position directly behind the child
seat to secure a child restraint top tether
strap.

If your vehicle is equipped with a split rear
seat, make sure the tether strap does not
slip into the opening between the seat-
backs as you remove slack in the strap.
WARNING!
The child restraint owner’s manual provides
instructions for installing the child restraint
using the seat belt. Read and follow these
instructions to install the child seat properly.
21_JL_OM_EN_EU_t.book Page 316