Jeep WRANGLER 2020, Руководство пользователя

Страница: 171 / 548

STARTING AND OPERATING 169
To increase the distance setting, push the
Distance Setting Increase button and release.
Each time the button is pushed, the distance
setting increases by one bar (longer).
To decrease the distance setting, push the
Distance Setting Decrease button and release.
Each time the button is pushed, the distance
setting decreases by one bar (shorter).
If there is no vehicle ahead, the vehicle will
maintain the set speed. If a slower moving
vehicle is detected in the same lane, the
instrument cluster displays the ACC Set With
Target Light, and the system adjusts vehicle
speed automatically to maintain the distance
setting, regardless of the set speed.
The vehicle will then maintain the set distance
until:

The vehicle ahead accelerates to a speed
above the set speed

The vehicle ahead moves out of your lane or
view of the sensor

The distance setting is changed

The system disengages
Ú
page 166
The maximum braking applied by ACC is limited;
however, the driver can always apply the brakes
manually, if necessary.
NOTE:
The brake lights will illuminate whenever the
ACC system applies the brakes.
A Proximity Warning will alert the driver if ACC
predicts that its maximum braking level is not
sufficient to maintain the set distance. If this
occurs, a visual alert “BRAKE!” will flash in the
instrument cluster display and a chime will
sound while ACC continues to apply its
maximum braking capacity.
NOTE:
The “BRAKE!” screen in the instrument cluster
display is a warning for the driver to take action
and does not necessarily mean that the
Forward Collision Warning system is applying
the brakes autonomously.
Overtake Aid
When driving with ACC engaged and following a
vehicle, the system will provide an additional
acceleration up to the ACC set speed to assist in
passing the vehicle. In locations with left hand
drive traffic, an additional acceleration is
triggered when the driver utilizes the left turn
signal and will only be active when passing on
the left hand side. In locations with right hand
drive traffic, an additional acceleration is
triggered when the driver utilizes the right turn
signal and will only be active when passing on
the right hand side.
NOTE:
When the vehicle transitions from a location
with left hand drive traffic to a location with right
hand drive traffic or vice versa, the ACC system
will automatically detect the direction of traffic.
ACC Operation At Stop
In the event that the ACC system brings your
vehicle to a standstill while following a target
vehicle, your vehicle will resume motion without
the need for any driver action if the target
vehicle starts moving within two seconds of your
vehicle coming to a standstill.
If the target vehicle does not start moving within
two seconds of your vehicle coming to a
standstill, the ACC with Stop system will cancel
and the brakes will release. A cancel message
will display on the instrument cluster display
and produce a warning chime. Driver
intervention will be required at this moment.
4
21_JL_OM_EN_EU_t.book Page 169