Jeep WRANGLER 2020, Руководство пользователя

Страница: 378 / 548

376 SERVICING AND MAINTENANCE
With the engine OFF and cold, the level of the
engine coolant should be within the OK range
between the ADD and FULL range on the
dipstick.
1. Remove the cap with level dipstick from
the engine coolant bottle.
2. Clean off the coolant from the dipstick.
3. Rest the cap on the opening of the coolant
bottle without tightening the cap.
4. Remove the cap with dipstick and check the
coolant level on the dipstick.
The radiator normally remains completely full,
so there is no need to remove the radiator/
coolant pressure cap unless checking for
engine coolant (antifreeze) freeze point or
replacing coolant. Advise your service attendant
of this. As long as the engine operating
temperature is satisfactory, the coolant bottle
need only be checked once a month.
When additional engine coolant is needed to
maintain the proper level, only OAT coolant that
meets the requirements of the manufacturer
Material Standard MS.90032 should be added
to the coolant bottle. Do not overfill.
Cooling System Notes
NOTE:
When the vehicle is stopped after a few miles/
kilometers of operation, you may observe vapor
coming from the front of the engine compart-
ment. This is normally a result of moisture from
rain, snow, or high humidity accumulating on
the radiator and being vaporized when the ther-
mostat opens, allowing hot engine coolant (anti-
freeze) to enter the radiator.
If an examination of your engine compartment
shows no evidence of radiator or hose leaks,
the vehicle may be safely driven. The vapor will
soon dissipate.

Do not overfill the coolant expansion bottle.

Check the coolant freeze point in the radiator
and in the coolant expansion bottle. If engine
coolant needs to be added, the contents of
the coolant expansion bottle must also be
protected against freezing.

If frequent engine coolant additions are
required, the cooling system should be pres-
sure tested for leaks.

Maintain engine coolant concentration at a
minimum of 50% OAT coolant (conforming to
MS.90032) and distilled water for proper
corrosion protection of your engine which
contains aluminum components.

Make sure that the coolant expansion bottle
overflow hoses are not kinked or obstructed.

Keep the front of the radiator clean. If your
vehicle is equipped with air conditioning,
keep the front of the condenser clean.

Do not change the thermostat for Summer or
Winter operation. If replacement is ever
necessary, install ONLY the correct type ther-
mostat. Other designs may result in unsatis-
factory engine cooling performance, poor gas
mileage, and increased emissions.
B
RAKE
S
YSTEM
In order to ensure brake system performance,
all brake system components should be
inspected periodically
Ú
page 347.
21_JL_OM_EN_EU_t.book Page 376