Jeep WRANGLER 2020, Руководство пользователя

Страница: 169 / 548

STARTING AND OPERATING 167
To Cancel
The following conditions cancel the ACC or Fixed
Speed Cruise Control systems:

The brake pedal is applied

The CANC button is pushed

The Anti-Lock Brake System (ABS) activates

The gear selector is removed from the DRIVE
position

The Electronic Stability Control/Traction
Control System (ESC/TCS) activates

The vehicle parking brake is applied

The braking temperature exceeds normal
range (overheated)

The Trailer Sway Control (TSC) activates
The following conditions will only cancel the ACC
system:

Driver seat belt is unbuckled at low speeds

Driver door is opened at low speeds
To Turn Off
The system will turn off and erase the set speed
in memory if:

The Adaptive Cruise Control (ACC) on/off
button is pushed

The Fixed Speed Cruise Control on/off button
is pushed

The ignition is placed in the OFF position

4WD Low is engaged
To Resume
If there is a set speed in the memory, push the
RES button and then remove your foot from the
accelerator pedal. The instrument cluster
display will show the last set speed.
Resume can be used at any speed above
19 mph (30 km/h) when only Fixed Speed
Cruise Control is being used.
Resume can be used at any speed above 0 mph
(0 km/h) when ACC is active.
NOTE:

While in ACC mode when the vehicle comes
to a complete stop longer than two seconds,
the system will cancel. The driver will have to
apply the brakes to keep the vehicle at a
standstill.

ACC cannot be resumed if there is a
stationary vehicle in front of your vehicle in
close proximity.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a collision
and death or serious personal injury.
4
21_JL_OM_EN_EU_t.book Page 167