Jeep WRANGLER 2020, Руководство пользователя

Страница: 481 / 548

GETTING TO KNOW YOUR VEHICLE 19
To stop the charging process:

Press the “STOP” button located on the front
of the charging station.

Press the button on the charge connector
first and then remove the connector from the
vehicle charge inlet.

Plug the charge handle into the charging
station and coil the charging cord onto its
holder. Do not leave the charging cord laying
on the ground.
C
HARGING
T
IMES
The following factors determine the time it
takes to charge the high voltage battery:

The high voltage battery’s current state of
charge

The type of charging cable used (Mode 2
(230 V) or Mode 3 (16 Amp))

Ambient temperature

Whether the vehicle’s ignition is in the RUN
position during charging
NOTE:

The charging times below are estimates
based on charging a high voltage battery that
has a <1% State Of Charge (SOC) value
displayed in the instrument cluster.

Charging times will vary based on the age,
condition, state of charge, and available
current being provided to the charger from its
energy source, and temperature of the high
voltage battery.

Charging times may be longer if a thermal
self-protection reduces the charging current
from the charging cable.

If the vehicle’s ignition is in either the ACC or
RUN position, the vehicle charge indicator
may not indicate greater than a 99% state of
charge, and will continue to charge the
vehicle, due to the vehicle loads.
V
EHICLE
C
HARGE
I
NDICATORS
Instrument Cluster High Voltage Battery Display
There is a battery display indicator located on
the instrument cluster. The battery display will
display the current state of charge for the high
voltage battery; with the percentage value
located to the right of the symbol. When
plugged in, the battery symbol also gives the
battery level along with messages about the
charge or whether the system is waiting to
charge due to the charge schedule. These will
appear unless there is a charging fault. A green
plug telltale will be shown in the cluster, as well
as applicable messaging when charging.
High Voltage Battery Display
Type of EVSE
Estimated Charge
Time
Mode 2 (230 Volt)
Approximately
5 hours
Mode 3 (16 Amp)
Approximately
2 hours
2
21_JL_H_SU_EN_EU_t.book Page 19