Jeep WRANGLER 2020, Руководство пользователя

Страница: 265 / 548

SAFETY 263
HDC Target Set Speeds

P = No set speed. HDC may be enabled but
will not activate

R = 0.6 mph (1 km/h)

N = 1.2 mph (2 km/h)

D = 0.6 mph (1 km/h)

1st = 0.6 mph (1 km/h)

2nd = 1.2 mph (2 km/h)

3rd = 1.8 mph (3 km/h)

4th = 2.5 mph (4 km/h)

5th = 3.1 mph (5 km/h)

6th = 3.7 mph (6 km/h)

7th = 4.3 mph (7 km/h)

8th = 5.0 mph (8 km/h)

9th = 5.6 mph (9 km/h) – If Equipped
NOTE:
During HDC the +/- shifter input is used for HDC
target speed selection, but will not affect the
gear chosen by the transmission. When actively
controlling HDC the transmission will shift
appropriately for the driver-selected set speed
and corresponding driving conditions.
Driver Override
The driver may override HDC activation with
throttle or brake application at any time.
Deactivating HDC
HDC will be deactivated but remain available if
any of the following conditions occur:

The driver overrides HDC set speed with
throttle or brake application.

Vehicle speed exceeds 20 mph (32 km/h)
but remains below 40 mph (64 km/h).

Vehicle is on a downhill grade of insufficient
magnitude, is on level ground, or is on an
uphill grade.

Vehicle is shifted to PARK.
Disabling HDC
HDC will be deactivated and disabled if any of
the following conditions occur:

The driver pushes the HDC button.

The driveline is shifted out of 4WD Low.

The parking brake is applied.

The driver door opens (Driver door opens if
doors are attached or driver seat belt is
unbuckled if doors are detached).

The vehicle is driven greater than 20 mph
(32 km/h) for greater than 70 seconds.

The vehicle is driven greater than 40 mph
(64 km/h) (HDC exits immediately).

HDC detects excessive brake temperature.
Feedback To The Driver
The instrument cluster has an HDC icon and the
HDC button has an indicator light, which offers
feedback to the driver about the state HDC is in.

The cluster icon and switch indicator light will
illuminate and remain on solid when HDC is
enabled or activated. This is the normal oper-
ating condition for HDC.

The cluster icon and switch indicator light will
flash for several seconds then extinguish
when the driver pushes the HDC button but
enable conditions are not met.

The cluster icon and switch indicator light will
flash for several seconds then extinguish
when HDC disables due to excess speed.

The cluster icon and switch indicator light will
flash when HDC deactivates due to over-
heated brakes. The flashing will stop and
HDC will activate again once the brakes have
cooled sufficiently.
6
21_JL_OM_EN_EU_t.book Page 263