Jands Event 4, Руководство пользователя

Страница: 67 / 78

Software Version 5.0
25/11/02 Draft Page 67
17.3.1 Setup Ctrl P1/2 - Reversing the P2 Master Fader
Some operators who use the Preset faders while running a show prefer to move the
two Preset Master faders together, to crossfade between Presets. To allow this on an
Event 4 the Preset 2 Master fader can be reversed so that at the top of its travel output
from Preset 2 is zero (0) and at the bottom of its travel the output is 100%.
Set P1/2 dbo Smast Chs Stack
Ctrl Norm Momt Hold Normal Single
P1/2
This field can be set to:
Norm
The P1 and P2 faders both move from zero at the bottom to 100% at the
top.
Rev The P2 fader moves from 100% at the bottom to zero at the top.
17.3.2 Setup Ctrl DBO – Changing DBO operation
The Dead Blackout button (DBO) scales all intensity channels to zero.
Set P1/2 dbo Smast Chs Stack
Ctrl Norm Momt Hold Normal Single
DBO
This field can be set to:
Momt
All intensity channels are Blacked Out only while the DBO button is held
down.
Ltch
The DBO button must be pressed once to BlackOut and again to restore
intensity.
17.3.3 Setup Ctrl Smast – Using the Hold Master
This field sets the function of the Hold master fader.
Set P1/2 dbo SMAST Chs Stack
Ctrl Norm Momt Hold Normal Single
SMast
This field can be set to:
Hold
Pressing the button above the Hold fader takes a snapshot of the console
output and retains that information until the button is pressed again. The
fader can be used to fade the intensity of this snapshot in and out.
Asgn The Hold fader scales the intensity of all Assign master faders.
Xfade
The Hold fader can be used to crossfade between any 2 memories on the
Assign faders as follows:
1. Press and hold the
Sample
button above the Hold fader.
2. Press the Flash button beneath any of the Assign faders.
3. Release both buttons.
4. Move the Hold fader up to fade in the chosen Memory.