JANDS – Event 4 Version 5 Users Manual
Page 36
Revision 5.0.0.5
25/11/02
Press the button above the field and press the IFCB buttons to change the
Mask settings.
Time
Sets any or all of Intensity, Focus, Colour and Beam to use timing during
playback. Any letter (IFCB) shown indicates that the parameter will fade
in and out using times set in the Memory menu. Eg. if the display shows
IF--, then when triggered, the Intensity and Position parameters will
follow the fade time, while the colour and beam will snap to the new
value.
Press the button above the field and press the IFCB buttons to change the
Time settings.
10.2.1
The Memory menu
Press the
Mem
button to open the Memory menu. There are 2 levels to this menu.
When the cursor is moved to the
more
field additional parameter fields are displayed.
Mem M—10 Infade Outfade Next
M 10.00 ---- 0:02.0 0:02.0 M 11 more
Mem Delay Mask Time Time Code
M 10.00 0:00.0 ---- IF-- --:--:--:--
Mem
This field sets the Memory number to be recorded or adjusted.
Label
Type a label of up to eight characters using an external keyboard or the
Flash buttons. (see below for a more detailed explanation of labelling)
Infade
This field sets the time the Memory will take to fade from 0% to 100%,
ie. if set to 0:10.5, it will take 10.5 seconds to fade to full output.
NOTE:
By default the Outfade field automatically tracks the infade time – that is, if
the infade time is changed the outfade time field changes to the same value. To set a
different outfade time simply move the cursor to the outfade field and change it.
Outfade
This field sets the time the Memory will take to fade from 100% to 0%,
ie. if set to 0:02, it will take 2 seconds to fade out.
Next
This field sets which item follows the Memory or Chase when used in a
Stack. See the section on Stacks for information on usage.
TIP:
To change the
Next
field setting from a Memory number to a Chase, press
the + (On) or – (Off) button to edit the field, use the left arrow button to move the
cursor over the M, then press the + (On) button to change the M to a C, (this can also
be achieved by pressing the Flash button marked C. In the Chase menu press flash
button M to change to a memory number.
Delay
This field is used to set automatic follow on and sets the time between the
Infade completion of this Memory and the start of the Infade of the
Memory or Chase set in the NEXT field. See the section on Stacks for
information on usage
Note:
A delay setting of 0:00.0 means that delay is Off.
Mask
Sets the parameters to be masked during playback. See the following
section for information on usage.
Содержание Event 4
Страница 1: ...EVENT 4 User Manual Version 5...