Jands Event 4, Руководство пользователя

Страница: 60 / 78

JANDS – Event 4 Version 5 Users Manual
Page 60 Revision 5.0.0.5 25/11/02
16.3.5 Taking Manual Control of a Fade
It is not unusual to need to take control of a Cue to allow for changes that occur in a
live performance. A performer might be late arriving on stage or skip over some part
of the show.
To take manual control of a fade, move the fader to match the elapsed fade
percentage. The LCD window changes to show MAN: / 20% (or whatever fade
percentage has elapsed). The fader can now be moved up or down to control the
progress of the crossfade. If the fader is taken to 100% the crossfade is completed. For
two fader stacks either or bother Infade and Outfade can be controlled this way.
To take manual control from the beginning of the Cue, pull the fader down to zero
before pressing the Go button.
NOTE: Leaving the Outfade under manual control means that all subsequent
memories will come under manual control when the fade percentage reaches the
fader setting. Thus if Memory 2 was taken under control after 50% of the fade time
had elapsed it would stay on at 50%. If the fader was left at this level the next press of
GO would cause Memory 3 to fade to 50% and Memory 2 to fade from 50% to 25%
(ie. 50% of 50%).
16.3.6 Taking Manual Control when a Fade has completed
When a crossfade is completed, the fader that normally controls the Outfade time
changes to control the stage level. The fader can then be used to scale the intensity of
the current Memory or Chase.
16.4 Clear Output from a Stack
To clear the output from a Stack:
1. Press the Clear button on the function keypad.
2. Press the
Go
(Flash) button of the Stack to be cleared.
Clearing a Stack snaps the current output from the Stack to zero level. However, the
Stack is still ON and a new infade can be started by pressing the Go (Flash) button
again.
16.5 Altering the Playback Order
Cues normally run in a sequential order or according to the settings in the NEXT field
of each Memory and Chase. However, it is possible to quickly move forward or
backwards in a Stack to run a different Cue.
To run a Cue other than the one showing above the Infade fader button:
1. Press the
Assign
button followed by the
Memory
(or Chase) button.
2. Enter the required Memory / Chase number.
3. Press the Stack GO (Flash) button.
The required Memory is now ready as the next Memory. Pressing the GO button will
initiate Infade.