Jacobsen Eclipse 322, Руководство по ремонту

Страница: 62 / 336

3-30 4222983 Second Edition
GENSET AND BATTERY PACK
3
3. Raise the hood.
Figure 3-51
4. Close fuel shutoff valve (1). (Turn clockwise until
valve bottoms lightly.)
Figure 3-52
NOTE
Fuel tank capacity is 5.3 gal (20 L). Have suitable
container(s) available that can hold up to 6 gal (23 L) of
fuel.
5. Loosen hose clamp (4).
6. Tag and disconnect fuel hose (2) from fuel filter (3).
Cap fuel filter fitting to prevent leakage and
contamination.
7. Place fuel hose (2) into a suitable container at a level
lower than the bottom of the fuel tank. Loosen the
fuel cap to provide a vent for draining fuel.
8. Open the fuel shutoff valve (1) at the bottom of the
fuel tank.
9. When fuel tank is completely empty, tighten fuel cap.
10. Close fuel shutoff valve (1). (Turn clockwise until
valve bottoms lightly.)
11. Plug fuel hose (2) to prevent leakage and
contamination.
Figure 3-53
12. Tag and disconnect wire connector (17).
13. Loosen hose clamps (5 and 10).
14. Tag and disconnect tank-to-canister hose (8) from
the rollover valve (19). Cap fitting and plug hose to
prevent leakage and contamination.
15. Tag and disconnect canister-to-manifold hose (18)
from the canister (7). Cap fitting and plug hose to
prevent leakage and contamination.
16. Remove screws (6) and canister assembly (9) and
secure out of the way.
17. Remove screw (13), lock washer (14), and flat
washer (15).
18. Lift and disengage strap (12) from fuel tank bracket
(16) and secure out of the way.
19. Remove fuel tank (11) from machine.
20. Tag and disconnect fuel hose (2) from bottom of fuel
tank.
Installation Notes
• Install fuel tank by reversing the order of removal.
• Use only clean gasoline of the correct type (unleaded
gasoline with minimum 85 octane rating) from a
clean, sealed container.
• If fuel was contaminated, install a new fuel filter at
this time. (See “Fuel Filter (Gas)” on page 3-31.)
1
TN2696
TN2796
4
2
3
15
TN2704
14 13
7
18
17
6
9
5
10
8
12
11
16
19