Jacobsen Eclipse 322, Руководство по ремонту

Страница: 253 / 336

CHASSIS
4222983 Second Edition 5-11
5
Disassembly Notes
• Before disassembly, clean the center lift arm and
center swing arm—removing all dirt and debris.
• Inspect link arm, center lift arm, center swing arm,
reel steering pivot, and all bushings for damage or
wear. Remove bushings only if replacement is
required.
Assembly Notes
• Before assembly, verify that the bushings and mating
surfaces are free of burrs, dirt, and debris.
• Repair or replace the link arm, center lift arm, center
swing arm, or reel steering pivot, if necessary.
• Replace any bushings that are damaged or have
excessive wear.
• Apply ant-seize compound to key (26) prior to
assembly.
• Install shim washers (23) as required to remove
excess gap between center lift arm (26), link arm
(27), and center reel steering pivot (22).
Steering Yoke
Removal and Installation
See Figures 5-12 through 5-14.

WARNING
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
Figure 5-12
2. Swing out and lock the center cutting unit (1) from
under the machine.

WARNING
IMPORTANT
It is important to lift and support the machine, or the
machine will move.
3. Lift the machine so that the rear wheel is off the
ground and support with appropriate jackstands.
4. Remove the rear wheel and axle assembly. (See
“Rear Wheel and Axle Assembly” on page 7-12.)
5. Remove the steering chain and steering gear. (See
“Steering Chain and Gears” on page 5-12.)
Required Materials
Anti-Seize Compound
Be sure that the key switch is off, all electrical
accessories are turned off, and the 12-volt and
48-volt power connectors are disconnected
before starting work on machine.
• Support the machine using properly rated
jackstands. Never work under a machine
supported only by a jack.
• Do not use wood or concrete blocks to
support the machine. Failure to properly
support the machine may result in death or
serious injury.
1
TN2388