ITT GOULDS PUMPS ICO i-FRAME, Инструкция по установке, эксплуатации и обслуживанию

Страница: 65 / 108

6.2.4 Regrease the grease-lubricated bearings
NOTICE:
Risk of equipment damage. Ensure that the grease container, the greasing device, and the fit-
tings are clean. Failure to do so can result in impurities entering the bearing housing while re-
greasing the bearings.
1. Wipe dirt from the grease fittings.
2. Fill the grease cavities through the fittings with a recommended grease.
3. Wipe off any excess grease.
4. Recheck the alignment.
The bearing temperature usually increases by 5°C to 10°C | 9°F to 18°F after you regrease due to an
excess supply of grease. Temperatures return to normal in about two to four operating hours as the
pump runs and purges the excess grease from the bearings.
6.3 Maintenance schedule
Maintenance inspections
A maintenance schedule includes these types of inspections:
• Routine maintenance
• Routine inspections
• Three-month inspections
• Annual inspections
Shorten the inspection intervals appropriately if the pumped fluid is abrasive or corrosive or if the envi-
ronment is classified as potentially explosive.
Routine maintenance
Perform these tasks whenever you perform routine maintenance:
• Lubricate the bearings.
• Inspect the seal.
Routine inspections
Perform these tasks whenever you check the pump during routine inspections:
• Check the level and condition of the oil through the sight glass on the bearing frame.
• Check for unusual noise vibration, and bearing temperatures.
• Check the pump and piping for leaks.
• Analyze the vibration.
• Inspect the discharge pressure.
• Inspect the temperature.
• Check the seal chamber and stuffing box for leaks.
• Ensure that there are no leaks from the mechanical seal.
• Adjust or replace the packing in the stuffing box if you notice excessive leaking.
Three-month inspections
Perform these tasks every three months:
6.3 Maintenance schedule
Model ICO i-FRAME, ICOH i-FRAME Installation, Operation, and Maintenance Manual 63