Intesis
Box
®
KNX
– IR Universal AC
User's manual r1.0 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
[email protected]
+34 938047134
36 / 48
•
If a
“0”
value is sent to
the
Control_ Switch Off Timeout
after the timeout period, no action will
be performed.
➢
Lock ON when Open
If set to
“no”
, On/Off commands while the window is open will be accepted.
•
If a
“1”
value is sent to the
Control_ Switch Off Timeout
object the switch-off timeout period will
begin again.
•
If a
“0”
value is sent to
the
Control_ Switch Off Timeout
object, no action will be performed.
If set to
“yes”
, On/Off commands, while the window is open, will be saved (but not applied). These
commands will be used in the next parameter if set to
“yes”
.
Enable use of Occupancy function
This parameter shows/hides the
Control_ Occupancy Input
communication object which lets you apply different
parameters to the indoor unit depending on the presence/no presence in the room.
o
If set to
“no”
the object will not be shown.
o
If set to
“yes”
the
Control_ Occupancy
object and new parameters will appear. If a
“1”
value is sent to this
object (no room occupancy), the timeout will begin. If a
“0”
value is sent to this object, the timeout will stop.
Figure 4.33
Parameter detail
