IntesisBox IS-IR-KNX-1i, Руководство пользователя

Страница: 16 / 48

Intesis Box
®
KNX
– IR Universal AC
User's manual r1.0 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel http://www.intesisbox.com
info@intesisbox.com
+34 938047134
16 / 48
General configuration
Inside this parameter
’s dialog it is possible to activate or change the parameters shown below:
Figure 5.2 General parameters
5.1.1 AC brand
Use the dropdown menu to select the AC brand of the AC unit you want to control.
In case your AC unit brand is not present, please select the IS-IR-KNX-1i and contact our support department
for more information about the Model to select.
5.1.2 Model
Use the dropdown menu to select the AC brand of the AC unit you want to control.
In case your AC unit brand is not present in the AC brand list, please select the IS-IR-KNX-1i and contact our
support department for more information about the Model to select.
5.1.3
Delay before sending initial “Read” telegrams
This parameter sets the delay before the interface will send READ telegrams for the group addresses associated
on its
Control_ objects on bus recovery or application reset/start-up. All Control_ objects with both Transmit (T)
and Update (U) flags enabled will send READs and their values will be updated with the response when
received.
Valid values go from 10 to 60 seconds. This is to give time enough to other KNX devices on the bus to start-up
before sending the READs.
AC brand
AC unit model