Intesis
Box
®
KNX
– IR Universal AC
User's manual r1.0 eng
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SLU
URL
Email
tel
http://www.intesisbox.com
[email protected]
+34 938047134
26 / 48
5.5.4 Enable use of +/- obj for Vane Up-Down
This parameter shows/hides the
Control_ Vane Up-Down +/-
communication object which lets you change the
indoor unit vane position by using two different datapoint types.
o
If set to
“no”
the object will not be shown.
o
If set to
“yes”
the
Control_ Vane Up-Down +/-
object.
➢
DPT type for +/- Vane Up-Down obj
This parameter lets choose between the datapoints
0-Up / 1-Down [DPT_1.008]
and
0-Decrease / 1-
Increase [DPT_1.007]
for the
Control_ Vane Up-Down +/-
object.
➢
Rollover Vane at upper/lower limit
This parameter lets choose if roll-over will be enabled (
“yes”
) or disabled (
“no”
) for the
Vane Up-Down
+/-
object.
5.5.5 Enable use of Text object for Vane U-D
This parameter shows/hides the
Status_ Vane Up-Down Text
communication object.
o
If set to
“no”
the object will not be shown.
o
If set to
“yes”
the
Status_ Vane Up-Down Text
object will appear.
▪
Up / Increase
▪
Down / Decrease
Pos. 3
Pos. 1
Pos. 2
Only if Roll-over is enabled
Only if Roll-over is enabled
Pos. 5
Pos. 4
SWING
