Intermec PA30, Руководство пользователя, Страница: 115 / 143

Chapter 7 — Managing, Maintaining, and Troubleshooting the PA30
PA30 Print Engine User’s Manual 103
Replacing the Printhead: After you pull the printhead out, disconnect
the cables.
8
Connect the cables to the new printhead.
9
Slide the printhead into the print mechanism and hook the
bracket hooks on the shaft. Make sure the cables are clear of
the shaft and that the bracket hooks are seated properly on the
shaft.
10 Turn the prithead lift lever clockwise to close the printhead.
The magnet on the pressure arm should engage the printhead.
11 Load media and ribbon.
12
Close the PA30 access door.
Cleaning the PA30
To clean the PA30, wipe external surfaces with a soft cloth
slightly dampened with water or a mild detergent.
Cleaning the Label Stop Sensor
If the PA30 starts to feed out labels unexpectedly, there may be a
problem with the label stop sensor.
• Always remove the power cord before cleaning the PA30.
• Do not spray the PA30 with water or any other fluids.
• Do not use sharp tools to remove stuck labels.