Intergraph TDZ-400 Deskside, Руководство по установке и обслуживанию

Страница: 72 / 136

58 Chapter 5 - Upgrading the System
6. Push on the top edge of the SIMM until it snaps into the metal clips.
The socket tabs must fit inside the mounting holes of the SIMM.
7. Repeat steps 4 through 6 for each additional SIMM.
8. Replace the graphics and PCI option boards and close the base unit.
9. Restart the system. The new memory is recognized automatically.
Adding Internal SCSI Devices
You can install internal SCSI devices such as hard disk drives, tape drives,
and CD-ROM drives in the auxiliary drive bays of the deskside workstation.
However, a bracket must be removed from the destination bay prior to
installation. Also, if the device is more than one inch high, then the bay
underneath must be empty since the bays are designed to accommodate one-
inch high devices.
Note: If purchasing SCSI devices from another vendor, carefully follow
the vendor’s instructions for setting the SCSI ID and disabling the
SCSI termination before installing the devices.
➤
To install an internal device in the auxiliary drive bay:
1. Select a bay to install the device and remove the blanking plate or
other device from the destination bay.
2. Remove the screw that secures the disk drive slide bracket from the
destination bay, and remove the bracket. Refer to the following
figure.