Intergraph TDZ-400 Deskside, Руководство по установке и обслуживанию

Страница: 50 / 136

36 Chapter 4 - Maintaining the System
4. Connect the SCSI cable, power cable, and audio cable to the CD-
ROM drive. The SCSI cable red stripe (pin 1) must be adjacent to the
power connector.
Note: If installing a non-Intergraph CD-ROM drive, use the audio cable
delivered with the new CD-ROM drive.
5. Close the base unit.
Combo Drive
Use a quarter-inch nutdriver and a No. 1 Phillips screwdriver to remove and
install the combo drive.
➤
To remove the combo drive:
1. Remove the top cover, and the left and right side panels.
2. Remove the CD-ROM drive as described in “Replacing the CD-ROM
Drive.”
3. Disconnect the floppy cable, ISA bus cables, and power cable from
the combo drive as shown in the following figure. Note the position
of the red stripe on the floppy cable.