Intergraph TDZ-400 Deskside, Руководство по установке и обслуживанию

Страница: 56 / 136

42 Chapter 4 - Maintaining the System
2. Secure the new disk drive to the bracket using the screws removed
previously.
3. Slide the disk drive assembly into the chassis. Secure the disk drive to
the chassis with the screws removed previously.
4. Attach the power cable and SCSI cable to the new disk drive. The
SCSI cable is keyed to ensure proper insertion. The red stripe (pin 1)
must be adjacent to the power connector.
5. Close the base unit.
6. Restart the workstation.
7. Partition and format the auxiliary hard disk drive as described in the
operating system documentation.
Riser Card
➤
To replace the riser card:
1. Remove the option board bracket as described in Chapter 3.
2. Disengage the riser card from the system board, and remove the card
from the base unit.
3. Insert the riser card into the system board slot, pushing firmly over the
center of the PCI connectors.
CAUTION
Do not rock the riser card back and forth; pins inside the connector may
be damaged as a result. Press firmly so the card connector slides evenly
into the slot.
4. Replace the option board bracket. Do not tighten the pivoting ISA
board guide until the ISA boards have been installed.
5. Replace the option boards connected to the riser card. Connect any
external cables attached to the boards. ISA boards must be installed in
the same slots from which they were removed.