Intergraph TDZ 2000, Настройка системы

Страница: 53 / 98

41
When you reprogram the flash EPROM, resource assignments for ISA option boards and PC
Card devices are lost. Your system may have installed ISA option boards or PC Card
devices that require specific system resources such as interrupts (IRQs) or input/output (I/O)
port addresses. If so, after reprogramming the BIOS, you must run the BIOS Setup again
and reallocate the system resources in the PCI/PnP Setup menu.
The FPU is available from the Intergraph Bulletin Board Service or Intergraph Online. See
“Using the Intergraph Bulletin Board Service” and “Finding Intergraph on the Internet” in
the Preface of this document for details.
CAUTION Reprogramming the flash EPROM erases all the parameter settings in the BIOS. If you
customized any BIOS settings, record them before reprogramming the flash EPROM.
To reprogram the BIOS:
1. Do one of the following:
−
From the IBBS login, go to Intergraph Product Centers, then Systems and
Networking, select File Libraries, and then select Delivered Drivers
−
From the Intergraph Online home page on the Internet, click Drivers and Updates,
and follow the links
2. Select the appropriate operating system and hardware platform. Then, find the FPU
(FLASHPROG) product and download it to a directory on your system.
3. Use an unzip utility to open the FLASHPROG product and extract the files from it.
4. Insert a blank 3.5-inch high-density floppy diskette into the floppy disk drive.
5. At the MS-DOS command prompt, in the directory containing the extracted files, key in
the following to create a MS-DOS boot diskette that contains the flash utility and the
BIOS files:
md c:\temp
install.bat
6. Shut down and power off the system; then restart the system.
7. At the MS-DOS command prompt, type in the following to run the FLASHPROG
product:
flash.exe
The following messages display, depending on the version of your BIOS.
Intergraph flash programming utility
Reading 841xx.ROM .
Programming flash EPROM
Flash EPROM updated.
Reboot the system by turning the power off.
Do not use ctrl-alt-del for rebooting.