Intergraph TDZ 2000, Настройка системы

Страница: 45 / 98

33
Build MPS Table for Uniprocessor
When this parameter is set to Yes, the BIOS enables single-processor systems to use the
multi-processor kernel. The default is No.
Memory Data Integrity Mode
ECC mode (default) provides error correction for data stored in memory. Parity mode
provides error detection for data stored in memory. The other setting is None.
Fixed Memory Hole
When set to Enabled, this parameter allows the memory in a RAM option card to be patched
into a specific location in the system’s memory, to accommodate ISA cards requiring a fixed
range of addresses. The default is Disabled. Options are 512KB-640KB and 15MB-16MB.
Generate NMI on System Error
This parameter halts the system when a catastrophic error is detected. This prevents the
error from corrupting your data. The default is Enabled.
AGP Aperture Size
The default is 64 MB. Options are 4 MB, 8 MB, 16 MB, 32 MB, 64 MB, 128 MB, and
256 MB.
VGA Frame Buffer USWC Mode
When enabled, the system performs write combining on VGA write commands. This
reduction in the amount of data written to the display improves system performance by
reducing the amount of bus traffic. The default is Disabled.
First Type F DMA
When set to Enabled, this parameter allows the system to transfer data to an ISA option card
at a faster rate than normal. However, the ISA option card must support Type F DMA
transfers. The default is Disabled.
First Type F DMA Channel
This parameter selects which DMA channel is used for Type F DMA transfers with the first
ISA option card. Not available (grayed) by default.