Intergraph TDZ 2000, Настройка системы

Страница: 83 / 98

71
Configuring PCMCIA Settings
If your TDZ 2000 contains a PCMCIA solution, you must adjust settings in the Control
Panel before you can use any PC cards. You also must ensure there is a free IRQ for use
with the PC Card adapter.
To configure PCMCIA settings:
1. From Start, click Settings, and then click Control Panel.
2. Double-click the Devices icon.
3. Select Atdisk, and then click Startup.
4. Select System, and then click OK.
5. Select PCMCIA, and then click Startup.
6. Select Boot, and then click OK.
7. Click Close.
NOTE You must have BIOS version 8410E or newer installed to use PCMCIA functionality. Earlier
versions of the BIOS do not support PCMCIA adapters.
If there is not a free IRQ for use with the PC Card adapter , you must disable some system
resources to free an IRQ; an unused serial port is a good choice. To disable a serial port, see
the serial port AMIBIOS Setup parameters in Chapter 4, “Configuring the BIOS.”
Restoring a Pre-configured Striped Disk Set
If your TDZ 2000 shipped with the striped disk option, you may need to restore the stripe set
to return the disk subsystem to its original performance capabilities. Pre-configured striped
disk set options consist of the following:
u
Two SCSI disk drives of equal size. The system disk has a 1 GB partition that contains
the operating system. The remainder of the system disk and an equivalent amount of the
second disk are striped together. The remainder of the second disk is unformatted.
u
Three SCSI disk drives of equal size. The system disk has a 1 GB partition that
contains the operating system. The remainder of the system disk is free storage space.
The other two disks are striped together.
Use Disk Administrator to restore the stripe set. See Disk Administrator Help for details on
using the disk utility.