Intel SBXL52 - Server Compute Blade, Руководство по техническому обслуживанию аппаратной части

Страница: 60 / 126

46
SBXL52: Hardware Maintenance Manual and Troubleshooting Guide
Each hot-swap hard disk drive that you plan to install must be mounted in a hot-swap-drive tray. The
hard disk drive must have a Single Connector Attachment (SCA) connector. Hot-swap-drive trays
come with the hot-swap hard disk drives.
For a list of SCSI hard disk drives supported by your blade server, refer to the "Intel Tested
Hardware and Operating System List".
The following illustration shows how to install a SCSI hot-swap hard disk drive.
Complete the following steps to install a SCSI hot-swap hard disk drive in a storage expansion unit.
Attention: To maintain proper system cooling, do not operate the SBCE unit for more than one
minute without either a hot-swap hard disk drive or a filler panel installed in each storage expansion
unit bay.
1.
Review “Electrical Safety” on page vi and “Installation guidelines” on page 27.
2.
Remove the filler panel from one of the empty hot-swap bays by inserting your finger into the
depression at the top of the filler panel and pulling it away from the expansion unit.
3.
Install the SCSI hot-swap hard disk drive:
a.
Ensure that the tray handle is open (that is, perpendicular to the hard disk drive).
b.
Align the hard disk drive assembly with the guide rails in the bay.
c.
Gently push the hard disk drive assembly into the bay until it stops.
d.
Push the tray handle to the closed (locked) position.
e.
Check the hard disk drive LEDs to verify that the hard disk drive is operating properly.