Intel SBXL52 - Server Compute Blade, Руководство по техническому обслуживанию аппаратной части

Страница: 47 / 126

Installing options
33
Removing the blade server from the SBCE unit
The following illustration shows how to remove the blade server from the SBCE unit.
Attention:
•
To maintain proper system cooling, do not operate the SBCE unit for more than one minute
without either a blade server, expansion unit, or filler blade installed in each blade bay.
•
Note the bay number. Reinstalling a blade server into a different bay than the one from which it
was removed could have unintended consequences. Some configuration information and update
options are established according to bay number; if you reinstall the blade server into a different
bay, you might need to reconfigure the blade server.
Complete the following steps to remove the blade server:
1.
If the blade server is operating, shut down the operating system; then, press the power-control
button (behind the blade server control panel door) to turn off the blade server. See “Blade server
controls and LEDs” on page 6 for more information about the location of the power-control
button.
Attention: Wait at least 30 seconds, until the drives stop spinning, before proceeding to the
next step.
2.
Open the two release levers as shown in the illustration. The blade server moves out of the bay
approximately 0.6 cm (0.25 inch).
3.
Pull the blade server out of the bay. Spring-loaded doors further back in the bay move into place
to cover the bay temporarily.
4.
Place either a filler blade or another blade server in the bay within one minute. The recessed
spring-loaded doors will move out of the way as you insert the blade server or filler blade.
Opening the blade server cover
The following illustration shows how to open the cover on the blade server.