Intel SBXL52 - Server Compute Blade, Руководство по техническому обслуживанию аппаратной части

Страница: 52 / 126

38
SBXL52: Hardware Maintenance Manual and Troubleshooting Guide
Before you begin, read the documentation that comes with your option.
Complete the following steps to install a DIMM:
1.
Review “Electrical Safety” on page vi and “Installation guidelines” on page 27.
2. Shut down the operating system, turn off the blade server, and remove the blade server from the
SBCE unit. See “Removing the blade server from the SBCE unit” on page 33 for instructions.
3.
Carefully lay the blade server on a flat, non-conductive surface.
4.
Open the blade server cover. See “Opening the blade server cover” on page 33 for instructions.
5.
Locate the DIMM connectors on the system board. Determine the connectors into which you
will install the DIMMs. (See note 3 on page 37)
6. Touch the static-protective package that contains the DIMM option to any unpainted metal
surface on the SBCE chassis or any unpainted surface on any other grounded rack component.
Then, remove the DIMM from the package.
7. To install the DIMMs, repeat the following steps for each DIMM that you install:
a. Turn the DIMM so that the DIMM keys align correctly with the connector on the system
board.
Attention: To avoid breaking the retaining clips or damaging the DIMM connectors,
handle the clips gently.
b.
Insert the DIMM by pressing the DIMM along the guides into the connector. Be sure that
the retaining clips snap into the closed positions.
Important: If there is a gap between the DIMM and the retaining clips, the DIMM has not
been properly installed. In this case, open the retaining clips and remove the DIMM; then,
reinsert the DIMM.
8.
If you have other options to install or remove, do so now; otherwise, go to “Completing the
installation” on page 51.
Installing an additional microprocessor
Your blade server supports two microprocessors. With two microprocessors, your blade server can
operate as a symmetric multiprocessing (SMP) server. With SMP, certain operating systems and
application programs can distribute the processing load between the microprocessors. To use SMP,