Intel SBXL52 - Server Compute Blade, Руководство по техническому обслуживанию аппаратной части

Страница: 49 / 126

Installing options
35
Removing the blade server bezel assembly
To install certain options you must first remove the blade server bezel assembly. The following
illustration shows how to remove the bezel assembly from a blade server.
Complete the following steps to remove the blade server bezel assembly:
1.
Review “Electrical Safety” on page vi and “Installation guidelines” on page 27.
2. Open the blade server cover.
3.
Press the bezel-assembly release and pull the bezel assembly away from the blade server
approximately 1.2 cm (0.5 inch).
4.
Disconnect the control-panel cable from the control-panel connector.
5.
Pull the bezel assembly away from the blade server.
6.
Store the bezel assembly in a safe place.
Installing IDE hard disk drives
Your blade server has two connectors on the system board for installing optional 2.5-inch IDE hard
disk drives. Each IDE connector is on a separate bus.
Two IDE drives can be used to implement and manage RAID level-1 under both the Linux and
Microsoft Windows 2000 operating systems.
Attention: To maintain proper system cooling, do not operate the SBCE unit for more than one
minute without either a blade server, expansion unit, or filler blade installed in each blade bay.