Intel® Server System R2600SR Setup and Service Guide
40
3.9.2
Replacing the KVM Module
Complete the following steps to install a KVM module:
1.
Turn off the corresponding compute node with the KVM module to be removed.
2.
Remove the compute node (see Section 3.2.1).
3.
Remove the compute node cover (see Section 3.2.3).
4.
Remove the air baffle (see Section 3.3).
Figure 36. Installing the KVM module
5.
Connect required cables to the new KVM module.
6.
Carefully route cables through the drive bay and the drive backplane.
Note: When routing the cables through the drive bay and drive backplane, be sure that the USB connectors
on the KVM module are to the right to ensure the correct installation (see Figure 37).
Figure 37. KVM module
7.
Insert the KVM module into the compute node.
8.
Install and fasten the retaining screw on the right side of the compute node.
Содержание R2600SR Series
Страница 2: ...Blank page...
