Intel R2600SR Series, Руководство по установке и обслуживанию

Страница: 25 / 85

Intel® Server System R2600SR Setup and Service Guide
19
The table below references details of the individual codes within the IPMI commands listed above.
Table 3. Individual IPMI command code details
Net Function = 0x3A
Code Command Request, Response Data Description
0xF1
SMM network
control
Request:
•
Byte 1: Request type
–
0x00 = Query SMM network
status
–
0x01 = Enable
–
0x02 = Disable
Response:
•
Byte 1 – Completion Code
•
Byte 2 – SMM network status (for
Query request only)
This setting is used to set SMM network
status which value is disabled as default.
The BMC Controller command supports the
system chassis and compute node only.
3. Point the browser to the SMM web interface URL defined by the system administrator during initial
system configuration.
4. The out-of-factory default network settings are applied at the first use of the SMM (in this order):
a.
The SMM should use DHCP first. If the SMM cannot acquire an IP address from a DHCP server in 2
minutes, it will use a static IP address.
b. The default static IP address is: 192.168.70.100
c. Using Hyper Text Transfer Protocol Secure (HTTPS). (For example, https://192.168.70.100)
d. IPv4 enabled with static IP = 192.168.70.100
e. IPv6 enabled with local link address (LLA) IP. To calculate LLA IP, do the following:
1)
Split the MAC address of the SMM (39-A7-94-07-CB-D0) into two parts. Insert FF-FE in the
middle. (For example, 39-A7-94-FF-FE-07-CB-D0)
2) Convert the two hexadecimal digits at the left end of the string to binary. (For example,
00111001-A7-94-FF-FE-07-CB-D0)
3) Invert the value for bit 1 of the first byte. (For example, 00111011-A7-94-FF-FE-07-CB-D0)
4) Convert the binary digits at the left end of the string back to hexadecimal
5) Combine the hexadecimal digit pairs into 4-digit groups. (For example, 3BA7-94FF-FE07-
CBD0)
6) Replace dash (-) separators with colon (:) separators. (For example, 3BA7:94FF:FE07:CBD0)
7) Add FE80:: to the left of the string. (For example, FE80::3BA7:94FF:FE07:CBD0)
5. Type user ID and password assigned by a system administrator.
Default ID: USERID
Password: PASSW0RD (Note: The sixth character of PASSW0RD is the number zero).
6. Click Log in.
7. Change the password for the first login default
a.
The password complexity rules are:

Must be at least 10 characters in length
 Must contain at least one number (0 through 9)
 Must contain at least two of the following three categories:
–
An uppercase letter (A through Z)
–
A lowercase letter (a through z)
–
A non-alphabetic characters such as !@#$%^*-_+=().:`|?"\
8. Use the new password to log in.