118
Listening Mode Setup
—Continued
b. Front Speaker
This option configures the front speakers to use when
playing the source. Select the speakers you want to use.
This setting can be made when the “(Speaker B) Front
L/R” is set to “Main A” in the Speaker Configuration
sub-menu.
A (Default):
Outputs the source from the front speakers
configured to “Speaker A.”
B:
Outputs the source from the front speakers
configured to “Speaker B.”
A+B:
Outputs the source from the front speakers
configured to “Speaker A” and “Speaker B.” Note that
this option is not available when the front speakers are
in Bi-amp configuration.
c. Center Speaker
This option configures the center speaker to use when
playing the source. Select the speaker you want to use.
This setting can be made when the “(Speaker B)
Center” is set to “Main A” in the Speaker Configuration
sub-menu.
A (Default):
Outputs the source from the center speaker
configured to “Speaker A.”
B:
Outputs the source from the center speaker
configured to “Speaker B.”
A+B:
Outputs the source from the center speakers
configured to “Speaker A” and “Speaker B.”
d. Surr L/R Sp
This option configures the surround speakers to use
when playing the source. Select the speakers you want
to use. This setting can be made when the “(Speaker B)
Surr L/R” is set to “Main A” in the Speaker
Configuration sub-menu.
A (Default):
Outputs the source from the surround
speakers configured to “Speaker A.”
B:
Outputs the source from the surround speakers
configured to “Speaker B.”
A+B:
Outputs the source from the surround speakers
configured to “Speaker A” and “Speaker B.”
e. Subwoofer
This option configures the subwoofer to use when
playing the source. Select the terminal to which the
subwoofer you want to use is connected. This setting
can be made when the “(Speaker A) Subwoofer” is set
to an option other than “Not Used” in the Speaker
Configuration sub-menu. However, when the “(Speaker
B) Subwoofer” is set to an option other than “Main A”
in the Speaker Configuration sub-menu, the available
options will be “A” or “Not Used.”
A (Default):
Outputs the source only from the
subwoofer connected to the SUBWOOFER PRE OUT
A terminal.
B:
Outputs the source only from the subwoofer
connected to the SUBWOOFER PRE OUT B terminal.
A+B:
Outputs the source from the subwoofers
connected to the SUBWOOFER PRE OUT A and
SUBWOOFER PRE OUT B terminals.
Not Used:
No subwoofers are used for playback.
In Zone 2, you can set the following options.
a. Mode
This option allows you to configure the width of a
virtual sound image which is simulated using two
speakers while you use the Dolby Virtual Speaker
effect.
Wide:
The breadth of the sound image is emphasized.
Reference (Default):
The general 5.1 ch surround
sound is simulated.
b. Decode (2ch)
This option allows you to select the decode mode before
the Dolby Virtual Speaker effect is applied.
Dolby Pro Logic II:
The Dolby Virtual Speaker effect
is applied after the signal is decoded with Dolby Pro
Logic II.
DTS NEO:6:
The Dolby Virtual Speaker effect is
applied after the signal is decoded with DTS NEO:6.
This sub-menu allows you to enable/disable the Dolby
Headphone function when you use the headphones.
a. Mode
On (Default):
Enables the Dolby Headphone function.
Off:
Disables the Dolby Headphone function.
Dolby Headphone Setup Sub-menu
Содержание Integra Research RDC-7.1
Страница 1: ...AV Controller RDC 7 1 Instruction Manual...
