Integra Integra Research RDC-7.1, Инструкция по эксплуатации

Страница: 11 / 156

11
Index Parts and Facilities —Continued
For further operational instructions, see the pages
indicated in brackets [ ].
1
Power switch [52]
Press to turn on and off the main power supply for
the RDC-7.1. When the RDC-7.1 is turned on with
the [Power] switch, the [Standby] indicator lights.
• Before turning on the power, check to make sure
that all cords are properly connected.
• When the power is turned on, a sudden surge of
current will occur that may adversely affect the
operation of other devices. To prevent this, do not
plug the RDC-7.1 into the same circuit used by
sensitive equipment, e.g., computers.
2
Standby/On button and On indicator [52]
If pressed with the [Power] switch turned on, the
RDC-7.1 turns on and the display and [On] indicator
light up. If pressed again, the RDC-7.1 returns to the
standby state. In the standby state, the display and
[On] indicator are turned off and the RDC-7.1 cannot
be operated.
3
Standby indicator [9, 52]
Lights when the RDC-7.1 is in the standby state and
when a signal is received from the remote controller.
4
Remote control sensor [9]
5
Front display
6
Master Volume dial [52]
Use to control the volume in the main zone. The
volume for the remote zone (Zone 2 and Zone 3) is
independent.
7
Open/Close button
Press this button to open and close the front door
that covers the lower buttons.
8
Input source buttons and indicators (DVD,
Video 1–7, Tape 1-2, Tuner, Phono, CD, and
Net Audio) [52, 62, 65, 80]
Press these buttons to select the input source for the
main zone. When an input source is selected, the
indicator will light in blue.
To select the input source for the remote zone (Zone
2), first press the [Zone 2] button, and then the
desired input source button.
To select the input source for the remote zone (Zone
3) or recording out (Rec Out), first press the [Rec/
Zone 3] button, and then the desired input source
button.
9
Zone 2 (GRN) and Rec/Zone 3 (RED)
Indicator [70, 72]
For Zone 2, the indicator above the selected input
source button will light green. For recording or
Zone 3, it will light red. When the same input
source is selected for Zone 2 and Rec/Zone 3, it will
light orange.
0
Pure Audio indicator [61]
Lights during pure audio playback.
Getting Star
ted