Inivos ProXcide, Руководство пользователя, Страница: 34 / 57

34
www. inivos .com
INSTRUCTION MANUAL REVISION 4.0 • APRIL 2020
3. Power to the process monitor only is lost: Within 2 minutes, the
ProXcide™
main unit will
identify and respond to its loss of communication with the process monitor by automatically
entering into deactivation mode. Once power to the process monitor is restored it will connect
to the main unit again and display the progress of the safety induced deactivation status.
In the event of power failure, the success of the decontamination depends on which stage of
the process the power failure occurred. The decontamination may have completed successfully,
but Operators are advised to check the process monitor display at the end of the deactivation
cycle to see whether the process needs to be re-run.
It is also exceptionally important that if Operators need to enter the treatment space due to
power failure, they only do so wearing appropriate personal protective equipment and only after
a portable gas leak detector produces an H
2
O
2
reading of ≤ 2ppm. Instructions on the use of a
portable gas leak detector can be found in Section 5.7
Please use the table on the following pages to resolve issues that may occur during operation
of the
ProXcide™
, where possible. If the advice is to contact Inivos, to avoid delay, it is vital that
you record the issue number that is shown on the process monitor screen.
Please ensure you quote the issue number when you call Inivos help-desk.
5.5 Troubleshooting Issues