Infortrend EonStor DS S12S-J2000-G, Руководство по оборудованию

Страница: 117 / 216

EonStor / EonStor DS S12/S16/S24 Series
135
Power On Status Check
LED(s) that light up
red
/
amber
nor should you hear an audible alarm from the
system. You should begin verifying system statuses via the following monitoring
 LEDs on LCD keypad panel
:
The LED on the LCD keypad panel should
illuminate after a successful initialization process, indicating that system
status is ready. System initialization and the power-on self-test may take
up to five minutes and the system fault LED may light up duri g the
process. The system fault LED will turn off after a successful boot-up
ocess (refer to Front Panel Components
As a general rule, once the system has been powered on, there should
NOT
be
interfaces:
n
pr ).
 LEDs on rear chassis, including controller module, PSUs, and cooling
modules (refer to System Monitoring
1
2
3 4
5
6
1 2 3 4 5 6
Ctr
l St
atu
s
CB
M S
tatu
s
1 2 3 4 5 6
).

ATTN LED: OFF
Controller LEDs:

Status LED: On
(
green
)

C_Dirty LED: Off

Temp LED: Off

CBM Status LED: On
(
green
) or Off
LCD Panel LEDs:

PWR LED: OFF
117