Industrial Scientific DSX-L, Руководство для стартапов

Страница: 91 / 120

87
*The two female Luer sizes are provided to support varied tubing diameters.
Note: Tubing measurement is Internal Diameter (ID).
Table 6-7. Manifold connections
Loosen and remove the two
thumb nuts on the manifold.
Separate the sections. Notice the manifold section with the threaded bolts
protruding. Place it around the neck of the regulator.
Slide the remaining section of the manifold over the
bolts of the first. Tighten the thumb nuts.
Connect the 3/16 ″ tubing
from the manifold inlet port
to the regulator nipple.
Connect each 1/8 ″ tubing from the manifold, to a docking
station gas inlet port.
Note : Unused ports on the manifold should be fitted with the Luer caps, included with the kit, to prevent leaking and
contamination.
DSSAC Manifold settings
The DSS server (DSSAC) software allows for the designation of the primary docking station,
and all of the docking stations in the manifold. Finish the manifold assembly by completing the
settings listed below.
•
Log in to the DSSAC web application and select “Docking Stations” from the left side
navigation menu.
•
Select a docking station serial number that is part of the manifold connections.
•
From its properties page, select the edit button for the gas inlet to which the manifold
tubing is connected. (See below)
•
Enter the primary docking station information for this setup.
•
Complete the Gas Inlet information for each non-primary docking station in the manifold as
shown below.