Impacts STREAMER S320RD, Руководство по эксплуатации

Страница: 49 / 68

Operating Manual S320RD
47
6. Close the cover (E), mount the bracket frame-housing (B) and fit the screws. Place the
setscrews (F) on the cover so the top liner is supported in the center.
7. Slightly tighten the setscrews (D) of the side liners.
8. Force the side liners (S) upwards so there is no gap between top and side liners. If necessary,
adjust top liner with the set screws (F) to the RH or LH side. Tighten up the set screws (D)
and all other liner screws.
9. Fit the wheel kit and front plate as described in Chapter 7.
10. Place the protection covers.
11. Remove the beam under the frame and lower the machine to the working position.
7.16 Replacing Filter Cartridges
Before you start changing the cartridges, you should clean as described in Chapter 6.3.
After that, remove the dustbin.
1. Unpack the new cartridges
and place them aside. Use the
packing for a dust free transport
and storing of the older cartridges.
2. Remove the locknut (1), steel-
washer (2) and rubber seal (3)
under the cartridge and pull down
the cartridge (4).
3. Place the cartridge in the packing
and seal it.
4. Place a new cartridge (4) on the
holder and push on the rubber
seal (3) to prevent the cartridge
from falling down again.
5. Then place the steel-washer (2) and nut. Tighten the nut (1).
6. Ensure the cartridge (4) centered to the Venturi on top and the seal (5) should not be fully
compressed when tightening up the nut (1).
7. Tightening it too much will damage the cartridge! Leave at least 5mm between metal top of
the cartridge and the upper plate of the filter housing.
7.17 Wear Parts - Filter Unit
To avoid unnecessary down time, IMPACTS Americas recommends to stock the following parts:
Part Number Description Qty.
306000002 Filter Cartridge 5
314000061 Compressor air inlet filter 1