Impacts STREAMER S320RD, Руководство по эксплуатации

Страница: 25 / 68

Operating Manual S320RD
23
11. Check the height of blasting machine's
distance between magnet and the floor.
It should be 3/8" (12mm). For height
adjustment, a 3/8 inch or 12 mm sheet
steel strip can be shifted below the
magnetic sealing (B). In order to adjust
it, you need to set the setting screws (C).
Also see chapter 7.
12. Replace or repair all damaged parts
before starting the machine.
13. Fill the separator equally with the selected
abrasive (see Chapter 3) up to the bottom
of the separator tray. The magnetic feed
valve must be closed while doing this.
Check Engine Oil Level
1. Fold the seat forward.
2. Remove the oil gauge (A) and wipe it with a lint-free
clean cloth.
3. Insert the oil gauge into tube (B) firmly fitting the plug
into the tube.
4. Remove oil gauge and check the oil level. The oil
level should be between the "H" (H) and "L" (L) marks
on the oil gauge.
5. If the oil level is near or below the "L" mark, remove
the oil filler cap (C) and pour some engine oil in slowly
to bring the oil level to the "H" mark. Recheck level.
Do not fill above the "H" mark. Excess oil will cause
a smoking condition, and may cause the engine to
overheat.
Check Hydraulic Oil Level
1. Check the hydraulic oil level at the oil level and
temperature indicator (T).
2. Lower the lifting cylinder, the oil level must be near the
"max." mark (H). See also chapter 7.