Impacts STREAMER S320RD, Руководство по эксплуатации

Страница: 16 / 68

S320RD Operating Manual
14
3.5 The Wheel Kit
The heart of every blast-machine is
the blast wheel (1) this will throw the
abrasive to the surface to treat, using
centrifugal forces. The blast wheel is
placed in a side force wheel housing
(2) protected with replaceable wear
plates (3).
The blast wheel is driven by a belt
drive and mounted on a bearing
unit (4). The correct rotation of the
S320RD blast wheel is CCW. (L)
The center of the blast wheel shows
a pre-accelerator, called impellor, (5)
feeding dosed quantities of abrasive
onto the blades of the turning blast wheel. On top of this is the control cage (2) which, once it is
carefully set, regulates the direction of the abrasive flow.
The Control Cage, held by two clamps needs to be adjusted (V) so the blast pattern shows to the
center of the machine. Turning the control cage CCW will move the Blast Pattern to the right and
turning it CW will move the blast pattern to the left.
3.6 The Separator
1 Separator housing
2 Deflector
3 Separator tray
4 Separator lid with baffle plate
5 Magnetic control valve
6 Feed spout
7 Abrasive control cable
8 Lever
9 Control lever magnetic-valve
The separator (1) is mounted to the end of the
rebound plenum. The deflector (2) and baffle plate
(4a) will stop the reflected abrasive.
The filter, connected to the hose connector (1b) will
generate an appropriate airflow within the separator
so this device will separate dust from abrasive. The
abrasive drops back to the storage where it has to
pass a wire mesh tray (3).