Impacts STREAMER S320RD, Руководство по эксплуатации

Страница: 24 / 68

S320RD Operating Manual
22
Chapter 5.0 Start Up
5.1 Preparing for Start Up
5.2 Refueling
5.3 Start Up
5.4 Initial Operation
5.1 Preparing for Start Up
Before start up, ensure that all existing protective housings are fitted and the filter unit is connected
correctly.
All persons in the proximity of the machine must wear safety glasses with lateral
protection as well as safety shoes. The operator is obliged to wear close fitting protective
clothing.
Carefully handle all plugs, cables, hoses, and operating devices. Avoid any contact with live wires.
Any work on the electrical system has to be done only by qualified specialists.
Check the surface before treatment for loose parts (stones, screws, etc.). The surface must be
swept if necessary. Make sure that the machine can travel over all inequalities on the surface.
Smaller inequalities, like weld seams or floor joints, will not effect the performance of the machine.
In order to avoid downtimes, a regular inspection is essential. Carry out the
following checks before any start-up:
Before start-up, operators and other personnel must be familiar with the safety regulations
given in this manual.
1. Check whether all machine parts are assembled safely and correctly.
2. Check all screws and other fasteners for tight seat.
3. Check the abrasive storage hopper, the feed spout, and the blast wheel parts for foreign
bodies and remove them.
4. Check blast wheel blades, impeller, control cage, liners, and fastening screws for damages
and wear.
5. Check the magnetic and brush seals for wear.
6. Make sure the dust container of the filter unit is empty. Please comply with the local waste
treatment regulations considering the removed material.
7. Check the separator parts for wear and defects. Remove foreign bodies and dust deposits in
order to prevent the separator from being blocked.
8. Check the electrical connections for dirt and foreign body deposits.
9. Check the level of abrasive in the storage hopper. Fill up if necessary.
10. Place the blast machine onto the surface to be treated.