Impacts STREAMER S320RD, Руководство по эксплуатации

Страница: 46 / 68

S320RD Operating Manual
44
Demounting Taper-lock Bushes:
1. Demount the screws (F) in the belt pulley
2. Lubricate the thread and the tip of the screw and turn it into the bore (L) as shown.
3. Turn the screw until the taper lock (B) gets loose inside the pulley and the assembly is loose
on the shaft.
4. Take the pulley and the taper lock from the shaft.
Mounting Taper-lock Bushes:
1. Assure that all contact surfaces are free from dirt and oil.
2. Place the taper lock into the pulley.
3. Lubricate the screws slightly and insert them into the respecting threaded holes.
4. Clean the shaft, shift the pulley with the taper lock, as one unit, onto the shaft, and position
the assembly. Note, that first the taper lock is fixed on the shaft before the pulley reaches its
final position on the bush.
5. Use an Allen key to fit the screws
6. Knock the frontal face of the bush lightly with a hammer to make sure that the bush is seated
in the centre of the pulley (use a mandrel to avoid any damages).
7. Now tighten the screws.
8. Repeat the alternating hammering and tightening until all screws fully tightened.
7.13 Wear Parts - Blast Housing
The Wheel Kit
1 Blast Wheel
2 Control Cage
3 Lock Washer
4 Bolt Liners
Liners
1 Top Liner
2 Top Plenum Liner
3 Side Liner Plenum RH
4 Side Liner Plenum LH
5 Bottom Plenum Liner
6 Side Liner