Impacts STREAMER S320RD, Руководство по эксплуатации

Страница: 31 / 68

Operating Manual S320RD
29
For daily operation of the integrated filter unit, please consider the following
points:
• Check daily the water separator (1) of the compressed air system.
• Weekly check the condition of the intake filter inlet (2) of the
compressor. This is strongly recommended, if the inlet shows dirt
and dust, it must be cleaned or replaced.
• During operation always observe the differential pressure (16) of
the filter cartridges, the pressure should not rise over 1.5 kPa. If
the differential pressure does not adjust visibly from the additional
cleaning of the cartridges under 1.5 kPa the cartridges must be
exchanged. The pressure (17) of the compressed air system
should reach 6 bar again during the pulse cycles.
• Weekly, open the exhaust valve (20) of the compressed air system
to discharge condensation.
All persons in the proximity of the machine must wear safety glasses with lateral
protection as well as safety shoes. The operator of the machine is obliged to wear close-
fitting protective clothing.
6.2 Information about the Chart Speed
The selection of the correct chart speed of the blast machine is essential for a good result. In the
case that the surface shows different characteristics, specifically different hardnesses or different
coating thicknesses, a uniform blast result will be achieved varying the chart speed while blasting.
The chart speed depends on the material of the surface to be blasted and the desired profiling.
The correct chart speed will be found out by observing the blasted surface and varying the speed
during the blast cleaning process. Combined display shows the travel speed (shown travel speed
divided by 10 is the travel speed in m/min).
Slight profiling on concrete requires a higher speed than coarse profiling.
Blasting on steel requires a very low chart speed.