Impacts STREAMER S320RD, Руководство по эксплуатации

Страница: 17 / 68

Operating Manual S320RD
15
This tray (3) is fitted to prevent any coarse contaminants from getting into the blast wheel. In order
to clean the wire mesh tray it can be removed from the side.
To regulate the flow of abrasive to the blast-wheel there is a magnetic-valve (5) fitted between
Storage-Hopper (1a) and feed spout (6).
This valve has a turnable shutter (5a) that is linked to a lever (8) controlled by the control cable (7).
Changing the angle of the shutter position results in a different amount of abrasive flowing to the
blast wheel. Feeding more abrasive causes more work and results in a higher load on the engine.
Load on the engine is indicated by the revolution counter.
Do not load more abrasive than recommended for the S320RD. The engine speed should be
between 3,250 and 3,300 min-1.
3.7 The Traction Drive
1 Hydraulic Drive Motor
2 Drive Wheel
3 Bypass Valve
The machine S320RD is driven by two hydraulic drive
motors (1). The drive wheels (2) are permanently
connected to the hydraulic drive motors.
To move the machine by hand, change the position of
the bypass valve (3). Once the machine is in place, be
sure to change back the position of the bypass-valve to
avoid inadvertent movements of the machine.
3.8 The Base Seals
1 Magnetic Seal
2 Brush Seal
3 Tail Seal
4 Adjuster Screw
5 Magnet Holder
6 Seal Plate
On the front and side are magnetic seals (1)
surrounded by brush seals (2). On the rear
you will find a seal called tail-seal (3). This
seal slides over the surface and prevents
abrasive getting out of the blast area.
All seals should seal against abrasive spray. The correct setting of the magnets is approx. 12mm
over the floor depending on the application. This setting is very important for best function of the
machine. The adjustment is done by setting screws. See chapter 5 for adjustment instructions.