Impacts STREAMER S320RD, Руководство по эксплуатации

Страница: 28 / 68

S320RD Operating Manual
26
After engine has started, carry out a test run with the following functions check:
1. Control the engine speed with the accelerator cable in various ranges, checking for free
movement of the cable.
2. Check hydraulic control functions for forward/backward drive and lift/lower for smooth function.
3. Turn steering wheel to both end positions and check steering for function.
Do not run the engine to warm on idle. The engine quickly reaches its operating
temperature under moderate load and at varying speed. To warm up the engine run it
for 3 to 5 minutes before putting the equipment under full load.
Idle 1550 min-1
Activation speed of the coupling ca. 1800 min-1
Work engine speed 3200 min-1
Fault displays during operation
If these warning lights display:
• charge current (5)
• engine oil pressure (9a), or
• coolant temperature (6)
then, the engine must be switched off immediately. The engine may not be started again until the
fault has been repaired. For fault search and remedies, see chapter 9.
4. When all function tests have been carried out perfectly and operating temperature has been
reached, the machine is ready for use.
5. To operate the machine in a forward motion, bring the engine speed up to 2400 min-1.
5.4 Initial Operation
1. Adjust the working engine speed of 3200 min-
1 with the accelerator cable (14). Above the
activation speed of coupling from ca. 1800 min-1,
the blast wheel, fan, and compressor are driven by
the transfer gearbox.
2. Push the traction drive lever (11) slowly forward (V),
until the required speed, shown in the combined
display (9), has been reached.
3. When pushing the traction drive lever forward, also
pull the abrasive valve lever (10) towards direction
(A) so the abrasive valve opens and abrasive flows
towards the blast-wheel.