Impacts S210E, Руководство по эксплуатации

Страница: 37 / 48

Operating Manual S210E
35
Failure Possible Reasons for Failure Failure Corrective Actions
Reduced performance
or no performance
Blast wheel or control cage
Blast wheel or control cage worn
out. Replace worn items.
Belt tension Check and adjust
Valve does not close properly and
abrasive is blocking the blast wheel
when switch is on.
Close valve, stop motor, and
readjust valve.
Too much abrasive emitted when
switched on. Ensure motor has max speed
before opening the valve,
Feed motion too fast. Reduce speed.
Losing Abrasive Bad seals
Check base seals readjust and
replace when worn.
Elevation adjustment of magnets
Check elevation to be no higher
than 8mm.
Magnets lost field Replace magnets
Filter unit Adjust reducing damper
Dumping or Losing
Abrasive
Poor Abrasive quality Use Quality abrasives
Blast Wheel worn Replace Blast Wheel
Worn Seals Replace Seals
Elevation adjustment of magnets
Readjust elevation of magnets
and adjust seals
Too much dust and sand in system Check filter
Too much dust and
other particles in
storage
Insufficient air flow toward filtration
unit Check rated performance of the
filter unit connected.
Check all seals
Check dust hose
Check differential pressure and
replace filter elements if pressure
is too high.